Hi Didi,

I manage to reproduce this error locally.
Is there something you would like me to check?

Regards,
Galit

On Sun, May 3, 2020 at 1:37 PM Yedidyah Bar David <didi@redhat.com> wrote:
On Sun, May 3, 2020 at 12:57 PM oVirt Jenkins <jenkins@ovirt.org> wrote:
>
> A system test invoked by the "ovirt-master" change queue including change
> 108705,9 (ovirt-engine) failed. However, this change seems not to be the root
> cause for this failure. Change 107284,12 (ovirt-engine) that this change
> depends on or is based on, was detected as the cause of the testing failures.
>
> This change had been removed from the testing queue. Artifacts built from this
> change will not be released until either change 107284,12 (ovirt-engine) is
> fixed and this change is updated to refer to or rebased on the fixed version,
> or this change is modified to no longer depend on it.
>
> For further details about the change see:
> https://gerrit.ovirt.org/#/c/108705/9
>
> For further details about the change that seems to be the root cause behind the
> testing failures see:
> https://gerrit.ovirt.org/#/c/107284/12
>
> For failed test results see:
> https://jenkins.ovirt.org/job/ovirt-master_change-queue-tester/23505/

The engine did manage to run ssh-copy-id to both host-0 and host-1, but
then failed, a few seconds later, while running ansible:

https://jenkins.ovirt.org/job/ovirt-master_change-queue-tester/23505/artifact/basic-suite.el7.x86_64/test_logs/basic-suite-master/post-002_bootstrap_pytest.py/lago-basic-suite-master-engine/_var_log/ovirt-engine/engine.log

2020-05-03 05:54:49,779-04 ERROR
[org.ovirt.engine.core.common.utils.ansible.AnsibleExecutor]
(EE-ManagedThreadFactory-engine-Thread-1) [13ea1de1] Error executing
playbook: Failed to add host to inventory: SSH timeout waiting for
response from 'lago-basic-suite-master-host-0'

A few other lines along this one, as well as similar ones for host-1,
do not give (me) more information.

lago did manage to collect logs from both hosts, a few seconds later.
vdsm logs are empty, messages does not give me a clue.

What is the timeout on trying to ssh (with ansible)? engine.log shows
only 1-2 seconds from start to timeout. Perhaps we should make it a bit
longer?

Best regards,
--
Didi
_______________________________________________
Devel mailing list -- devel@ovirt.org
To unsubscribe send an email to devel-leave@ovirt.org
Privacy Statement: https://www.ovirt.org/privacy-policy.html
oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/
List Archives: https://lists.ovirt.org/archives/list/devel@ovirt.org/message/WQ3JDHUPHR42VNWYBE7DGF4LRLOVC4V2/


--

GALIT ROSENTHAL

SOFTWARE ENGINEER

Red Hat 

galit@redhat.com    T: 972-9-7692230