I reinstalled the hosts

step:
1) create new host  > I selected srv-02
2) host created

1) create new host  > I selected srv-03
2) host created


and noticed two things :

1) I tried now, to remove the remaining VMs , but the error was the same : Cannot remove VM. VM is attached to a VM-Pool.

2) I can run theses VMs . That is, I can remove the host and reinsert again without VM problems.
2.1)  And another detail: these VMs are thin/dependent.

All others VMs that I was able to remove was the type clone/independent.


What happens with this thin type provisioning?



On Tue, May 6, 2014 at 1:42 PM, Tamer Lima <tamer.americo@gmail.com> wrote:
hello

what is the correct procedure to remove VMs and Hosts? 
I know the right way is to remove VMs first then remove your Host,
but I generate 20 VMs, just for testing, and I want to remove either the host who hosts this VMs

Environment:
3 servers:
srv-01 = engine , vdsm
srv-02 = vdsm  ,  spm, lots of VMs
srv-03 = vdsm , lots of VMs


I removed 2 hosts of my ovirt-engine
steps:
1) select host and put on maintenance
2) stop all VMs 
3) remove host

But in VM tab I can see all VMs and can not remove .

steps

1) select VM and click on remove
 Are you sure you want to remove the following items?
- pvm0203-2
Remove Disk(s)

2) click ok
Operation Canceled
Error while executing action:
pvm0203-2:
    Cannot remove VM. VM is attached to a VM-Pool.


What really happens here?  Where is this files located to remove manually? 

thanks


thanks