I am attempting to update my Puppet module [1] that manages oVirt and have found my method for executing engine-setup works on a fresh install but fails if run after install, for example to enable reports.
Normally I run this:
yes 'Yes' | engine-setup --config-append=/var/lib/ovirt-engine/setup/answers/ovirt-engine-setup.conf
However if I've already installed ovirt-engine and then install the packages for reports and re-run the above command it gets stuck at this step:
[ INFO ] Stage: Setup validation
During execution engine service will be stopped (OK, Cancel) [OK]:
Since "Yes" is not a valid response my method does not work. Is there a flag I can provide in the answers file that would prevent the above prompt? I am semi familiar with using expect but was hoping to avoid using expect from within a Puppet module.
Thanks,
- Trey