Dis you enable libgfapi ?<div id="yMail_cursorElementTracker_1631206645078">engine-config -s LibgfApiSupported=true</div><div id="yMail_cursorElementTracker_1631206647757"><br></div><div id="yMail_cursorElementTracker_1631206647938">Note: power off and then power on the VM. The qemu process should not use the '/rhev' mountpoints.</div><div id="yMail_cursorElementTracker_1631206678410"><br></div><div id="yMail_cursorElementTracker_1631206678616">Also, share your current setup:</div><div id="yMail_cursorElementTracker_1631206693159">- disks</div><div id="yMail_cursorElementTracker_1631206704071">- hw controller</div><div id="yMail_cursorElementTracker_1631206709292">- did you storage align your block devices (hw raid only)</div><div id="yMail_cursorElementTracker_1631206731956">- tuned-profile</div><div id="yMail_cursorElementTracker_1631206745743">- sysctl settings that are changed</div><div id="yMail_cursorElementTracker_1631206761634">- gluster volume options that are changed<br><div id="yMail_cursorElementTracker_1631206567805"><br></div><div id="yMail_cursorElementTracker_1631206568045">Best Regards,</div><div id="yMail_cursorElementTracker_1631206571518">Strahil Nikolov</div></div>