Thanks for your reponse, No I have not tried that but I was able use the iso image and install the vm but when the vm starts it does not have internet connection even after configuring eth0 with a valid ip address. I decided to start over but there is no easy way to start over. Also the disk that was used for installing the VM could not be reused even though there is plenty of space on it. It seems it says it could not be initialized, I had to use the delete the raid config and readd through the BOIS setup to be able to reuse the disk.
I am trying again one more time and see. I hope there is a way to make the disk available again after a failed setup instead of the above mentioned method.
Thanks
On Wed, Mar 23, 2016 at 8:15 PM, Modou Conteh
<modou.m.conteh@googlemail.com> wrote:
>
> I am seeking some assistance installing Ovirt Self hosted Engine, but I keep getting and error at the end "System not stable or unable to read dev/mapper etc. here is the log file from my last try. I am testing this for use at work as a test environment, there I have a single server to run this on the reason I choose the Self Hosted Engine. I guess the instructions is not clear either, i.e when i try to disk install with Cento OVA I get and error, and finally when I choose the cdrom it work fine until the end and fail to initialize /dev/mapper, etc.
> Any assistance will be highly appreciated.
>
Did you tried running
yum install ovirt-engine-appliance
?
It will download a ready to use Centos base appliance with oVirt engine on it.