Hello Folks,

I want to use OVS as network switch in oVirt 4.1, While Creating a cluster i select OVS as switch type and all LAN ports of ovirt hosts or hypervisor are configured in trunk mode on the network switch.

Logical networks are created and attached to the bond interface(consists of LAN cards of my hypervisor).

Inline image 1

In case of legacy network or Linux bridging either we usually assign the IP address or vlan id to logical network but while using OVS what needs to be used ..? Do i need to configure any other settings to use OVS.

What i want to achieve with OVS is that i have around 10 VLANs and want to use these VLANs in different VMs in my oVirt Setup. If i go with Legacy switch then i have to create 10 different logical networks.

Thanks in adavnce

Best Regards
Pradeep Kumar