On Mon, Nov 26, 2018 at 8:18 PM David Gossage
<dgossage@carouselchecks.com> wrote:
>
> I have an older 3.6.7 setup I am still using at a location. The hosted-engine is up but not responding
>
> {"reason": "failed liveliness check", "health": "bad", "vm": "up", "detail": "up"}
>
> I am guessing it got into some paused or halted state after a power outage and storage went offline for a short bit and I may need to manually perform some tasks. When I attempt the suggested method of
> hosted-engine --set-maintenance --mode=global
> hosted-engine --console
>
> I get an error about
>
> Use the password you've set using --add-console-password for logging in
>
> ** (remote-viewer:11479): WARNING **: Could not open X display
> Cannot open display:
> Run 'remote-viewer --help' to see a full list of available command line options
Recent versions configure the hosted-engine vm to use a serial console,
which is much easier to use (if you have no X on the host).
For older versions, you might want to check a page I wrote some time ago,
that does not exist anymore on the website, but can be found at archive.org:
http://web.archive.org/web/20150704004004/http://www.ovirt.org:80/Hosted_Engine_Console
Good luck and best regards,
>
> Their are 7 other VM's running I was able to manually continue from vdsClient
>
> Is their a way to get remote access to this engine?
>
> David Gossage
> Carousel Checks Inc. | System Administrator
> Office 708.613.2284
> _______________________________________________
> Users mailing list -- users@ovirt.org
> To unsubscribe send an email to users-leave@ovirt.org
> Privacy Statement: https://www.ovirt.org/site/privacy-policy/
> oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/
> List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/message/QVO7CA4MDK7BIJJWZPEP6JLPSAJMVQCD/
--
Didi