On Tue, Aug 9, 2016 at 4:28 PM, Arsène Gschwind <arsene.gschwind@unibas.ch> wrote:

Hi,

We have setup an oVirt 4 cluster using Gluster as storage backend.
I've setup a separate 10 Gb Network for Gluster traffic and tried to use that network as written in : https://www.ovirt.org/develop/release-management/features/network/select-network-for-gluster/

But I'm not able to find the "Edit - Brick" menu to be able to set the IP to use for existing bricks.
Is this not implemented yet? The feature status says "done".

I've been able to create new bricks using that network and it seems the traffic is going trough the right nics.

Edit brick feature that can change a brick's network is not implemented - it is dependent on the ability to call replace brick where source and destination brick are the same. This is currently not possible in glusterfs and hence https://gerrit.ovirt.org/51685 is not yet merged.

However, any brick that you create after you have associated gluster network with an interface, say nic2, will use the interface nic2 for creating bricks.

Thanks for any hint.
regards,

Arsène

_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users