Hello,

this morning I get these two messages regarding bond1 and its active interface on one host (ovmsrv07):

Host ovmsrv07 has network interface which exceeded the defined threshold [95%] (bond1: transmit rate[96%], receive rate [0%])

Host ovmsrv07 has network interface which exceeded the defined threshold [95%] (enp7s4f0: transmit rate[96%], receive rate [0%])

Actually there is no particular network activity during this latest night...

There have been some different resore jobs during past days...

How is determined this message? Is it perhaps cumulative?

On the host there are 3 VMs and only one of them actively using the network.

In its "Network Interfaces subtab I see

Total RX (bytes)

542,696,952,529

Inside VM OS:

$ uptime

 10:26:50 up 14 days,  1:35,  3 users,  load average: 0.00, 0.04, 0.05

$ ifconfig eth0

eth0      Link encap:Ethernet  HWaddr 00:1A:4A:17:01:5B  

          inet addr:10.4.4.66  Bcast:10.4.4.255  Mask:255.255.255.0

          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1

          RX packets:40280066 errors:0 dropped:612718 overruns:0 frame:0

          TX packets:21110417 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000 

          RX bytes:193066319488 (179.8 GiB)  TX bytes:20983189756 (19.5 GiB)

Almost confirmaed on host where I have these counter indeed, but I think they are cumulative for the VM, and not an alert in se....

ON ovmsrv07:

$ ifconfig bond1

bond1: flags=5187<UP,BROADCAST,RUNNING,MASTER,MULTICAST>  mtu 9000

        ether 00:1c:c4:ab:3a:dd  txqueuelen 1000  (Ethernet)

        RX packets 140610596  bytes 200368822262 (186.6 GiB)

        RX errors 0  dropped 126874  overruns 0  frame 0

        TX packets 33886066  bytes 21972025081 (20.4 GiB)

        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

$ cat /proc/net/bonding/bond1 

Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup)

Primary Slave: None

Currently Active Slave: enp7s4f0

MII Status: up

MII Polling Interval (ms): 100

Up Delay (ms): 0

Down Delay (ms): 0

Slave Interface: enp7s4f0

MII Status: up

Speed: 1000 Mbps

Duplex: full

Link Failure Count: 0

Permanent HW addr: 00:1c:c4:ab:3a:dd

Slave queue ID: 0

Slave Interface: enp7s4f1

MII Status: up

Speed: 1000 Mbps

Duplex: full

Link Failure Count: 0

Permanent HW addr: 00:1c:c4:ab:3a:de

Slave queue ID: 0

Could anyone clarify?

Thanks,

Gianluca

_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users