I think the documentation you followed may be a little outdated. From the new version:

https://www.ovirt.org/documentation/admin-guide/chap-Utilities/ 

"""
**Important:** The `ovirt-engine-rename` command does not update SSL certificates, such as `imageio-proxy` or `websocket-proxy`. These must be updated manually, after running `ovirt-engine-rename`. See "Updating SSL Certificates" below.

Updating SSL Certificates

Run the following commands after the ovirt-engine-rename command to update the SSL certificates:

"""

and there are 4 steps there.

Not sure if that's actually what's wrong, though :)

Best wishes,
Greg


On Sat, Dec 15, 2018 at 10:33 AM Douglas Duckworth <dod2014@med.cornell.edu> wrote:
For context the service reports to syslog, on ovirt-engine, that it's listening on the correct FQDN:

Dec 15 10:20:57 ovirt-engine journal: 2018-12-15 10:20:57,764-0500 ovirt-websocket-proxy: INFO msg:871   - Listen on correct_fqdn:6100

My /etc/ovirt-engine/ovirt-websocket-proxy.conf.d/10-setup.conf:

PROXY_PORT=6100
SSL_CERTIFICATE=/etc/pki/ovirt-engine/certs/websocket-proxy.cer
SSL_KEY=/etc/pki/ovirt-engine/keys/websocket-proxy.key.nopass
CERT_FOR_DATA_VERIFICATION=/etc/pki/ovirt-engine/certs/engine.cer
SSL_ONLY=True
TRACE_ENABLE=True
TRACE_FILE=/var/log/ovirt_websocket_proxy

In addition I don't see any trace output to the file "/var/log/ovirt_websocket_proxy"

Thanks,

Douglas Duckworth, MSc, LFCS
HPC System Administrator
Scientific Computing Unit
Weill Cornell Medicine
1300 York Avenue
New York, NY 10065
E: doug@med.cornell.edu
O: 212-746-6305
F: 212-746-8690


On Fri, Dec 14, 2018 at 4:54 PM Douglas Duckworth <dod2014@med.cornell.edu> wrote:
Hi 

I change the hostname of my hosted engine using script below:


However, as shown attached, the old hostname of "ovirt-engine.pbtech" seems to still be expected for some reason.  As a result I cannot connect to VMs via console.

Any idea on how to make WSS to use the proper hostname?

In file "https://www.ovirt.org/documentation/how-to/networking/changing-engine-hostname/" I defined "PROXY_HOST=FQDN" then restarted ovirt-websocket-proxy.service but no change.

Thanks very much!

Thanks,

Douglas Duckworth, MSc, LFCS
HPC System Administrator
Scientific Computing Unit
Weill Cornell Medicine
1300 York Avenue
New York, NY 10065
E: doug@med.cornell.edu
O: 212-746-6305
F: 212-746-8690
_______________________________________________
Users mailing list -- users@ovirt.org
To unsubscribe send an email to users-leave@ovirt.org
Privacy Statement: https://www.ovirt.org/site/privacy-policy/
oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/
List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/message/XDW3XX3SQG75NWIFOUSQTRJZYYN7QCR2/


--

GREG SHEREMETA

SENIOR SOFTWARE ENGINEER - TEAM LEAD - RHV UX

Red Hat NA

gshereme@redhat.com    IRC: gshereme