Hello,

my configuration is what described here:

http://lists.ovirt.org/pipermail/users/2017-March/080992.html

So I'm using iSCSI multipath and not bonding

can anyone reproduce?

Initial situation is only one node configured and active with some VMS

I go and configure a second node; it tries to activate but networks are not all already mapped and so gies to non operational.

I setup all networks and activate the node

It happens that:

- on the first node where I currently have 2 iSCSI connections and 2multipath lines (with p1p1.100 and p1p2) it is instantiated a new iSCSI SID using interface "default" and in multipath -l output I see now 3 lines

- on the newly added node I only see 1 iSCSI SID using interface default

My way to solve the situation was to go inside iscsi multipath section

do nothing but save the same config

brutally on first node

iscsiadm -m session -u

--> all iscsi sessions are closed

after a while I see again the original 2 connections recovered, with correct interface names used

- on second node 

iscsiadm -m session -u

--> the only session is cloed

nothing happens 

if I set to maintenance the node and then activate the node

--> the 2 correct iscsi sessions are activated...

Thanks

Gianluca

_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users