I have recently set up an ovirt engine server and one host.  The ovirt engine server was installed on a small Intell Atom quad core with 4 gigs of ram box.  The ovirt engine server is running on Fedora 16 and engine was installed from rpms after I added the repo.  Also I have installed one host or node if you prefer That is an AMD quad core with 8 gigs of ram and has virtualization.  I have tried installing from ovirt node 2.2.1 iso but ethernet card can not be intialized even though it is detected.  This is a realtek card and it shows up fine in fedora 16.  The iso is still a bit buggy for me so I tried installing fedora 16 and then the vdsm rpm packages from repository.  I have correctly set up a bridge on fedora 16 and by the way your instructions are wrong for bridge setup.  I will be glad to send you guys a correct config for the wiki if neccessary for fedora 16.  Vdsm is running and I installed host from the ovirt gui by adding new host entered ip config an.d it appeared in the ovirt web manager.  What it does not do properly is install on the Ovirt web manager I get installing then it says install failed.  I have tried reinstalling from the ovirt web manager to no avail.  The wiki is a good start but directions are lacking I must say.  Is there any more config that needs to be done on the vdsm.conf file in etc/vdsm/vdsm.conf or does it just "detect" when the Ovirt web manager calls for it?  I am probably missing something on my end I am guessing.  Also what log files would be helpful to look at?  I will be trying this out also on a new asus server with two 8 core amd opterons and 32 gigs of ram shortly so I will let you know how that goes also.  This project is great I just need to get a working host and I want to write a simpler install write up for this project that in my opinion is what it is lacking. 

Let me know,

--
Dominic Kaiser
Greater Boston Vineyard
Director of Operations

cell: 617-230-1412
fax: 617-252-0238
email: dominic@bostonvineyard.org