Hello,

I successfully installed Ovirt Node NG from ISO to an ISCSI target attached via first network interface by using following extensions to the grub cmdline:

"rd.iscsi.ibft=1 ip=ibft ip=eno2:dhcp"

I want to use the server as diskless ovirt-node-ng Server.

After successful install the system reboots and starts up but it fails later in dracut even having detected correctly the disk and all the LV's.

I think "iscsistart" is run multiple times even after already being logged in to the ISCSI-Target and that fails finally like that:

[  147.644872] localhost dracut-initqueue[1075]: iscsistart: initiator reported error (15 - session exists)
[  147.645588] localhost dracut-initqueue[1075]: iscsistart: Logging into iqn.2018-01.de.databay.office:storage01.epycdphv02-disk1 172.16.1.3:3260,1
[  147.651027] localhost dracut-initqueue[1075]: Warning: 'iscsistart -b ' failed with return code 0
[  147.807510] localhost systemd[1]: Starting Login iSCSI Target...
[  147.809293] localhost iscsistart[6716]: iscsistart: TargetName not set. Exiting iscsistart
[  147.813625] localhost systemd[1]: iscsistart_iscsi.service: main process exited, code=exited, status=7/NOTRUNNING
[  147.824897] localhost systemd[1]: Failed to start Login iSCSI Target.
[  147.825050] localhost systemd[1]: Unit iscsistart_iscsi.service entered failed state.
[  147.825185] localhost systemd[1]: iscsistart_iscsi.service failed.

-- 
Mit freundlichen Grüßen

Ralf Schenk