Hello Zois,

It pretty easy to do, via the webadmin UI , go to Hosts main tab > Choose host > go to 'Network Interfaces' sub tab > Press the 'Setup Host Networks' button > press the pencil icon on your management network > and  choose Static IP > press OK and OK to approve the operation.

- Note that in some cases, specially if this is a SPM host you will loose connectivity to host for few seconds and host may go to non-responsive state, on a non-SPM host usually this woks without any specific issues.

- If the spoken host is a SPM host, I recommend to set it first to maintenance mode, do the switch and then activate. For non-SPM host this will work fine as well when the host is UP.

Cheers)

On Mon, Mar 19, 2018 at 12:15 PM, zois roupas <roupas_zois@hotmail.com> wrote:

Hello everyone


I've made a rookie mistake by installing ovirt 4.2 in centos 7 with dhcp instead of a static ip configuration. Both engine and host are in the same machine cause of limited resources and i was so happy that everything worked so well that i kept configuring and installing vm's ,adding local and nfs storage and setting up the backup!

As you understand i must change the configuration to static ip and i can't find any guide describing the correct procedure. Is there an official guide to change configuration without causing any trouble?

I've found this thread http://lists.ovirt.org/pipermail/users/2014-May/024432.html but this is for a hosted engine and doesn't help when both engine and host are in the same machine


Thanx in advance

Best Regards

Zois


_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users




--

Michael Burman

Senior Quality engineer - rhv network - redhat israel

Red Hat

mburman@redhat.com    M: 0545355725     IM: mburman