Hello,

I'm on oVirt 4.1.7, the latest in 4.1 right now.

Initially in engine-setup when prompted I set Image I/O Proxy to false.

Configure Image I/O Proxy : False

Now instead I would like to enable it, but if I run engine-setup I can't find a way to do it. I can only confirm the settings in a whole or exit the setup...

How can I do?

Currently I have these packages already installed on the system

ovirt-imageio-proxy-setup-1.0.0-0.201701151456.git89ae3b4.el7.centos.noarch

ovirt-imageio-proxy-1.0.0-0.201701151456.git89ae3b4.el7.centos.noarch

and

[root@ovirt ~]# systemctl status ovirt-imageio-proxy

● ovirt-imageio-proxy.service - oVirt ImageIO Proxy

Loaded: loaded (/usr/lib/systemd/system/ovirt-imageio-proxy.service; disabled; vendor preset: disabled)

Active: inactive (dead)

[root@ovirt ~]#

Can I simply and manually enable/start the service through systemctl commands?

The same question arises in case I had not / had enabled VMConsole Proxy and/or WebSocket Proxy during install and in a second time I want to enable / diable them.

Thanks,

Gianluca