[Users] How do Networks and Vlan-tagging work in oVirt ?

[Gianluca Cecchi]

On Tue, Feb 12, 2013 at 10:27 PM, Moti Asayag  wrote:

>
> You should follow the next steps:
>
> 1. Create a new logical network from the networks main tab: define its
> data-center and set its vlan-id to 50 (the VM network checkbox should be
> checked)
> 2. Click on the created network in the networks main tab ---> Select the
> 'Clusters' sub-tab and ---> click on 'Assign/Unassign Network' and
> attach the network to the cluster (which contains the hosts that are
> expected to run the VMs).
> 3. Click on 'hosts' sub-tab of the network main tab for the same
> network. You should be able to see the cluster's hosts. Select a host
> and click on 'Setup Networks'.
> 4. In the 'setup networks' dialog you would see the host's interfaces on
> the left side and the logical networks definition on the right.
> Drag the network on top of an interface, or first drag a nic on top of
> another to create a bond and then drag the network to that bond.
> A command will be sent from the engine to the vdsm on the host to
> configure the desired network configuration.
> 5. In order to persist the network configuration on the host you can
> check the 'save network configuration' from 4.

Hello,
I followed these steps to create a bonded VM network (no vlan tagging)
with 3.2 beta.
Only differences
- assignement of network to cluster (step 2) can also be completed
while in step 1)

- step 3 : to see the host and setup networks for it you have to
select the "unattached" check box

I don't understand if and how I can put lan parameters if I don't use
vlan tagging
I don't see any option for that, when I edit the "network" itself or
go through the "setup host networks"

For example the VMs that will attach to this new network that I called
"client" will have ip of the form
10.10.10.x/24 with gw 10.10.10.1

and eventually I would like to give an ip address to the created bond
itself. Can I?

Thanks,
Gianluca