[Users] FW: ovirt 3.2.1 custom bonding options

[Sven Knohsalla]

Hi Dan,

I first tried this without setting miimode, but then miimode pull was set to 0ms (oVirt engine 3.2.1)
(via /proc/net/bonding/bond[n])

This was the reason why I added miimode=100 setting to custom bonding option in oVirt.
As this is a very common setting, I would suggest to make it default for oVirt too ?

Cheers,
Sven.

Sven Knohsalla | System Administration | Netbiscuits

Office +49 631 68036 433 | Fax +49 631 68036 111  |E-Mail s.knohsalla at netbiscuits.com | Skype: netbiscuits.admin 
Netbiscuits GmbH | Europaallee 10 | 67657 | GERMANY

-----Ursprüngliche Nachricht-----
Von: Dan Kenigsberg [mailto:danken at redhat.com] 
Gesendet: Mittwoch, 26. Juni 2013 09:04
An: Sven Knohsalla; Lior Vernia
Cc: users at ovirt.org
Betreff: Re: [Users] FW: ovirt 3.2.1 custom bonding options

On Wed, Jun 26, 2013 at 01:56:09AM -0400, Sven Knohsalla wrote:
> Hi,
> 
> for all oVirt users who wants to run their nodes in balance-rr mode:
> Go to "Network Interfaces"
> --> "Setup Host Networks"
> 
> Edit the bond interface you want to change
> --> "Bonding mode"--> "Custom:"
> --> "Custom mode" --> mode=0 miimon=100 (depends on your scenario)

Is there any reason not to include miimon=100 within the predefined "Mode 0" selection? I believe that Engine should.