[ovirt-users] workflow node installation

[Ryan Barry]

On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
> Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
>> Don't we have ovirtmgmt defined by default
>> during the registration process?
>
> Hey,
>
> IIRC that is done by ovirt-host-deploy during the registration, yes.
>
> - fabian
>
>> ----- Forwarded Message -----
>>> From: "Jorick Astrego" <j.astrego at netbulae.eu>
>>> To: "users" <users at ovirt.org>
>>> Sent: Monday, May 19, 2014 1:11:58 PM
>>> Subject: [ovirt-users] workflow node installation
>>>
>>> Hi,
>>>
>>> I don't know if I'm doing things wrong but the workflow for node installation
>>> is a bit cumbersome for me.
>>>
>>> The things I have to do to get a node up in ovirt engine:
>>>
>>> - install node image from pxe
>>> - approve node
>>> - put node into maintenance mode (storage not available)
>>> - Setup Host Networks
>>> - Sync network (otherwise I cannot save the network changes)
>>> - Setup Host Networks again
>>> - Save Network setup
>>> - activate node
>>>
This seems problematic to me -- the host networks should be
automatically set when you approve the node joining a given cluster.

Are you setting up the host networks on the engine side, or do you have
to approve, log back into the node, configure networking, etc?
>>> And this I have to do for every node. It could save me some time if I could
>>> setup the networks on approval or engine puts it directly into maintenance
>>> mode without the sync requirement.
>>>
>>> Kind regards,
>>>
>>> Jorick Astrego
>>> Netbulae B.V.
>>>
>>> _______________________________________________
>>> Users mailing list
>>> Users at ovirt.org
>>> http://lists.ovirt.org/mailman/listinfo/users
>>>
>
>