[ovirt-users] Hosted Engine: Cannot initialise host

[Dan Kenigsberg]

On Wed, Jul 22, 2015 at 09:23:46AM +0300, Yedidyah Bar David wrote:
> On Wed, Jul 22, 2015 at 2:34 AM, Alan Murrell <lists at murrell.ca> wrote:
> > Hi Dan,
> >
> > Quoting "Dan Kenigsberg" <danken at redhat.com>:
> >>
> >>     virsh -r dumpxml vdsm-ovirtmgmt
> >
> >
> > I will see if I can get you that output a little later, along with the
> > vdsClient output suggested by Yedidyah.
> >
> >> your own, you should also define that network. Skipping network
> >> definition might have worked in the past, but it would certainly not
> >
> >
> > When you refer to defining the "network definition", are you referring to a
> > "NETWORK=" line in my ifcfg-ovirtmgmt file (which I think was referred to by
> > Yedidyah)?
> 
> Dan refers to the below:

Actually, I was referring to placing a file (say /tmp/1.xml) with
    <network>
      <name>vdsm-ovirtmgmt</name>
      <uuid>f661da6b-6dea-8c4d-af7f-c0c9111ea10e</uuid>
      <forward mode='bridge'/>
      <bridge name='ovirtmgmt'/>
    </network>
and defining it in libvirt with

    virsh net-define /tmp/1.xml
    virsh net-start vdsm-ovirtmgmt

but not that I do not endorse it; the following is what should be followed:

> 
> >
> > If necessary, I can also blow away my current install and try the deployment
> > again without defining the bridge first, if for no other reason than if it
> > still fails to do so, it is a bug that that you will be aware of.
> 
> Yes, please do. This will be mandatory in 3.6.
> 
> Thanks, and please report back with any issue (or success :-) ).
> 
> Best,
> -- 
> Didi