[ovirt-users] connecting my oVirt engine to a 100mb switch

[Andrew Precht]

The switch is a Cisco 3750 v2, I also tried a cheep Netgear. I'll put in a
request to set the Cisco to 100 full and see if that helps.
Thanks

On Thu, May 28, 2015 at 6:24 AM, Genadi Chereshnya <gcheresh at redhat.com>
wrote:

> Hi Andrew
> I am not aware of any issue to connect engine to specific switch (try to
> connect other host to the switch to check this assumption)
> Looks like it's auto-negotiation issue.
> Try to disable it (on the switch side too)
>
> Regards,
>    Genadi
>
> ----- Original Message -----
> From: "Andrew Precht" <andrewprecht06 at gmail.com>
> To: users at ovirt.org
> Sent: Thursday, May 28, 2015 12:37:57 AM
> Subject: [ovirt-users] connecting my oVirt engine to a 100mb switch
>
>
>
>
> Hi all,
> I’m having problems connecting my oVirt engine to a 100mb switch. I’m not
> having any problems connecting to 1gb. But, I need to also have a
> connection to a 100mb network.
> I’ve tried configuring ethtool_opts on the interface. However, this only
> results in the NIC not coming up and showing: Speed: Unknown! and Duplex:
> Unknown! (255), when I run ethtool ethX
>
>
> Is it possible to connect the engine to a 100mb switch?
> Thanks
>
>
> PS. I also posted this question over on the oVirt G+ page. I apologize if
> that's incorrect but I have G+ open all day...
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20150528/58b5d246/attachment-0001.html>