[ovirt-users] management interface

Fernando Fuentes ffuentes at darktcp.net
Thu Aug 4 16:50:06 EDT 2016


Edward,

I am sorry that the diagram was not clear enough.

There is two bonds (4 phisical nic's, each pair is LACP). One for mgmt
traffic only and one to carry untag and tag traffic.
But I do understand your point.
I will try to separate this and have everything on its own access port.

To move my current ovirtmgmt interface to a new one all I have to do is
create one and assign it and remove the old one correct?
Thanks again!

Regards,



--
Fernando Fuentes
ffuentes at txweather.org
http://www.txweather.org



On Thu, Aug 4, 2016, at 02:07 AM, Edward Haas wrote:
> Hi Fernando,
> From what I could understand, you would like to have 3 networks, all
> on the same bond:
> (I do not understand from the diagram that you have two bonds, you
> mentioned only bond0)
> - ovirtmgmt - vlan35 at bond0
> - dmz vm network - vlan42 at bond0
> - default vm network - untag at bond0
>
> Based on the tag, traffic that enters bond0 will be forwarded to the
> relevant network.
> Any traffic that enters bond0 and is either untag or has a tag that
> does not correspond to the defined vlans,
> will be forwarded to the non-vlan network (default vm in this case).
> Note that when packets pass a vlan interface, they are stripped of
> their tag.
>
> I personally consider a mix of tag and untag on the same iface/port as
> bad practice, but there may be reasons to
> choose it. If you can, try having all networks with vlans, and set the
> switch ports correctly to reflect that.
> Any other device on the network, like the router, can be connected to
> the switch to an access port (say of vlan 100),
> so traffic there is untag, and when traffic goes to the ovirt host, it
> will go tagged 100.
> Thanks,
> Edy.
>
> On Tue, Aug 2, 2016 at 9:22 PM, Fernando Fuentes
> <ffuentes at darktcp.net> wrote:
>> __
>> I answer my own question.
>> "I think" lol
>>
>> I am going to create a new ovirtmgmt logical network with a vlan tag
>> and than move my hosts in to it for management. This interface is not
>> part of the vm network.
>>
>> The rest of the logical networks with vlans will be tagged and part
>> of the vm network.
>> I think that logic is right.
>> Thoughts?
>>
>>
>> Regards,
>>
>>
>> --
>> Fernando Fuentes
>> ffuentes at txweather.org
>> http://www.txweather.org
>>
>>
>>
>>
>> On Sun, Jul 31, 2016, at 11:43 PM, Fernando Fuentes wrote:
>>> Right now as we stand boht ovirt management and LAN data crosses the
>>> same interface.
>>> I have two bonds. I want to move ovirt management to its own bond
>>> and tag it with vlan id 35.
>>>
>>> Than I wan to move my LAN which has no tag and my dmz that does have
>>> a tag in to my secondary bond.
>>>
>>> The switch is all configured what I am not sure is when making the
>>> logical network do I make the LAN a "VM Network"?
>>> And the same question for my dmz tagged vlan...
>>>
>>> I attached a small diagram that explains what I am trying to
>>> accomplish... I hope :D
>>>
>>>
>>> Thanks for the help.
>>>
>>> Regards,
>>>
>>>
>>> --
>>> Fernando Fuentes
>>> ffuentes at txweather.org
>>> http://www.txweather.org
>>>
>>>
>>>
>>> On Sun, Jul 31, 2016, at 12:50 PM, Edward Haas wrote:
>>>>
>>>>
>>>> On Sun, Jul 31, 2016 at 7:19 PM, Fernando Fuentes
>>>> <ffuentes at darktcp.net> wrote:
>>>>> Team,
>>>>>
>>>>> Is it possible to move the ovirt management interface to a
>>>>> separate vlan
>>>>> and keep it from been on the same interface as my LAN?
>>>>
>>>> Networks, including the management one, can be assign as non-vlan
>>>> or as vlan on
>>>> different nics/bonds.
>>>> If you want to assign two or more networks on the same nic/bond,
>>>> only one can remain
>>>> non-vlan, the rest must be set with a vlan.
>>>> Vlan networks require that traffic entering the nic/bond is tagged,
>>>> therefore, the switch port
>>>> that the nic is connected to must be set as a trunk.
>>>> If you have a specific setup in mind, please draw a network diagram
>>>> for us.
>>>>
>>>>>
>>>>> IE: assign a tag to ovirtmanagement and keep another interface as
>>>>> untag
>>>>> for my LAN to use with the VM's
>>>>>
>>>>> Thoughts ideas?
>>>>>
>>>>> TIA!
>>>>>
>>>>> Regards,
>>>>>
>>>>> --
>>>>>  Fernando Fuentes ffuentes at txweather.org http://www.txweather.org
>>>>>  _______________________________________________
>>>>>  Users mailing list Users at ovirt.org
>>>>>  http://lists.ovirt.org/mailman/listinfo/users
>>>
>>> _________________________________________________
>>> Users mailing list
>>> Users at ovirt.org
>>> http://lists.ovirt.org/mailman/listinfo/users
>>> Email had 1 attachment:


>>>  * vlans.png 353k (image/png)
>>
>>
>> _______________________________________________
>>  Users mailing list
>> Users at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20160804/8350b755/attachment.html>


More information about the Users mailing list