[ovirt-users] LACP Bonding issue

[Bryan Sockel]

We checked the port groups, and servers are cabled correctly.

After server is rebooted, em1 is the only interface passing traffic.
Other 3 nics sitting idle.  We can down each port on the switch and
confirm it is down on the server.


I am pretty sure it is related to the bridge that was created to pass
vm-host-altn traffic when the appliance was first installed.



-------- Original message --------
From: Chris Adams <cma at cmadams.net> 
Date: 4/20/17 5:40 PM (GMT-06:00) 
To: users at ovirt.org 
Subject: Re: [ovirt-users] LACP Bonding issue 

  _____  

>From : Chris Adams [cma at cmadams.net]
To : users at ovirt.org [users at ovirt.org]
Date : Thursday, April 20 2017 17:40:25
Once upon a time, Bryan Sockel  said:
> It seems that is some disconnect between my network bridge, the bond
and my 
> interfaces.  I would like to some how get my bond to use all 4
interfaces.  
> On reboot, it always seems to reset consistently to EM1.

Are you sure the switch side is all the same LACP group?  Sounds like
one port may accidentally be in a separate group, and that happens to be
em1.

You might try swapping wires between em1 and another port and reboot and
see which ports come up - if all but the port with the wire formerly in
em1 come up, it points to the switch config.

-- 
Chris Adams 
_______________________________________________
Users mailing list
Users at ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20170420/6fb040ea/attachment.html>