[ovirt-users] hosted engine from appliance and firewalld/iptables-services

[Peter Hudec]

Thx, very helpfull.

	Peter

On 23/02/2017 11:49, Yedidyah Bar David wrote:
> On Thu, Feb 23, 2017 at 12:24 PM, Peter Hudec <phudec at cnc.sk> wrote:
>> Hi,
>>
>> I installedHE form the appliance and need to switch the from firewalld
>> to iptables-services.
>>
>> Does the HE /4.1.0/ depends on firewalld or could be switched to
>> iptables services? IS there any templte for iptables-servicec like for
>> the nodes `engine-config -a | grep -i  iptables`
> 
> I assume you refer to the engine machine. On hosts, only iptables
> is supported currently [1].
> 
> You can install and activate iptables-services, remove (or at least
> disable) firewalld, and then run engine-setup again. It should ask
> you if you want to configure iptables.
> 
> Whatever you reply, it should also create a file
> /etc/ovirt-engine/iptables.example
> you can use.
> 
> Best,
> 
> [1] https://bugzilla.redhat.com/show_bug.cgi?id=995362
> 
>>
>>         best regards
>>                 Peter Hudec
>> --
>> *Peter Hudec*
>> Infraštruktúrny architekt
>> phudec at cnc.sk <mailto:phudec at cnc.sk>
>>
>> *CNC, a.s.*
>> Borská 6, 841 04 Bratislava
>> Recepcia: +421 2 35 000 100
>>
>> Mobil:+421 905 997 203
>> *www.cnc.sk* <http:///www.cnc.sk>
>>
>> _______________________________________________
>> Users mailing list
>> Users at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
> 
> 
> 


-- 
*Peter Hudec*
Infraštruktúrny architekt
phudec at cnc.sk <mailto:phudec at cnc.sk>

*CNC, a.s.*
Borská 6, 841 04 Bratislava
Recepcia: +421 2  35 000 100

Mobil:+421 905 997 203
*www.cnc.sk* <http:///www.cnc.sk>