<div dir="ltr">Hello,<div>I&#39;m on oVirt 4.1.7, the latest in 4.1 right now.</div><div>Initially in engine-setup when prompted I set Image I/O Proxy to false.</div><div><br></div><div><div>          Configure Image I/O Proxy               : False</div></div><div><br></div><div>Now instead I would like to enable it, but if I run engine-setup I can&#39;t find a way to do it. I can only confirm the settings in a whole or exit the setup...</div><div>How can I do?</div><div><br></div><div>Currently I have these packages already installed on the system</div><div><br></div><div>ovirt-imageio-proxy-setup-1.0.0-0.201701151456.git89ae3b4.el7.centos.noarch<br></div><div>ovirt-imageio-proxy-1.0.0-0.201701151456.git89ae3b4.el7.centos.noarch<br></div><div>and</div><div><div>[root@ovirt ~]# systemctl status ovirt-imageio-proxy</div><div>● ovirt-imageio-proxy.service - oVirt ImageIO Proxy</div><div>   Loaded: loaded (/usr/lib/systemd/system/ovirt-imageio-proxy.service; disabled; vendor preset: disabled)</div><div>   Active: inactive (dead)</div><div>[root@ovirt ~]#</div></div><div><br></div><div>Can I simply and manually enable/start the service through systemctl commands?</div><div><br></div><div>The same question arises in case I had not / had enabled  VMConsole Proxy and/or WebSocket Proxy during install and in a second time I want to enable / diable them.</div><div><br></div><div>Thanks,</div><div>Gianluca</div><div><br></div></div>