Re: [JIRA] (OVIRT-2730) Running sub stages using https://jenkins.ovirt.org/job/standard-manual-runner/

On Wed, 15 May 2019 at 18:58, Nir Soffer (oVirt JIRA) < jira(a)ovirt-jira.atlassian.net&gt; wrote: Looking at the stdci.yaml file I get when cloning the patch - I don't see any substages or distroes defined in it, so STDCI does what it can in that case - run the default substage for the specified architectures that it can find script files for. Is this based on a very old version of vdsm's stdci.yaml ? You can see the exact same thing happening for check-patch triggered from Gerrit: https://jenkins.ovirt.org/blue/organizations/jenkins/vdsm_standard-check-... In fact running check-patch with manual runner is quite useless, since CI will always run it for you anyway when you push the patch... Because you can't select substages like that. check-network would not work since its not defined in stdci.yaml for that patch. It runs the exact same code. - allow selection of a sub stage? Probably not gonna happen - this would require some deep changes. - nice to have - allow selection of multiple sub stages Same as above, you can only select a stage at this point. > Nir > -- > This message was sent by Atlassian Jira > (v1001.0.0-SNAPSHOT#100102) > _______________________________________________ > Infra mailing list -- infra(a)ovirt.org > To unsubscribe send an email to infra-leave(a)ovirt.org > Privacy Statement: https://www.ovirt.org/site/privacy-policy/ > oVirt Code of Conduct: > https://www.ovirt.org/community/about/community-guidelines/ > List Archives: > https://lists.ovirt.org/archives/list/infra@ovirt.org/message/UITZXUPHTOZ... -- Barak Korren RHV DevOps team , RHCE, RHCi Red Hat EMEA redhat.com | TRIED. TESTED. TRUSTED. | redhat.com/trusted