[ovirt-users] Re: Problem with SAN FC and Ovirt 4.2

could you share the output of both command? On Thu, 2019-01-03 at 07:02 -0300, Sebastian Antunez N. wrote: Hello I see with multipath -ll and lsbls but not show the LUN Regards Sebas El jue., 3 ene. 2019 a las 3:57, Arsène Gschwind (<arsene.gschwind@unibas.ch<mailto:arsene.gschwind@unibas.ch>>) escribió: Hi, Do you see the LUNs on the Hypervisor using lsblk or multipath -ll ? rgds, Arsene On Wed, 2019-01-02 at 18:25 +0000, Sebastian Antunez N. wrote: Hello Guys I install 6 host with Ovirt 4.2 connected via FC to Brocade 300 switch and HP EVA P2000 Storage. Zoning was performed on each SAN switch and when creating a Virtual Disk with 3 LUN, but adding the Storage in OVIRT does not see any LUN. The OVIRT nodes were restarted, the Engine but still does not see the LUNs I have searched for information on how to resolve this issue but I have not had any information. I will appreciate your help in this regard as I have not been able to resolve the issue. Thanks to all Regards Sebastian _______________________________________________ Users mailing list -- <mailto:users@ovirt.org> users(a)ovirt.org To unsubscribe send an email to <mailto:users-leave@ovirt.org> users-leave(a)ovirt.org Privacy Statement: <https://www.ovirt.org/site/privacy-policy/> https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: <https://www.ovirt.org/community/about/community-guidelines/> https://www.ovirt.org/community/about/community-guidelines/ List Archives: <https://lists.ovirt.org/archives/list/users@ovirt.org/message/UPILMALCBD5... https://lists.ovirt.org/archives/list/users@ovirt.org/message/UPILMALCBD5...