[ovirt-users] Re: New to OVirt

I downloaded oVirt_Node ISO and deployed it to the servers. Than, I used the following instructions https://www.ovirt.org/documentation/gluster-hyperconverged/chap-Deploying... At first, I tried to deploy gluster to three servers, but it was giving me some issues on one of them. So, I used that document as a guide line for single deployment. After, the gluster was done I clicked on OVirt Engine setup wizard. I filled out the info so it can be deployed on the same server. However, the installation never finishes successfully. I can see that the host has a new virtual machine running, but it does not get the IP address from the wizard. The VM gets the IP from the newly created subnet. On Monday, May 13, 2019, 11:09:43 AM PDT, Joop <jvdwege(a)xs4all.nl&gt; wrote: On 10-5-2019 19:20, Slobodan Stevanovic wrote: > > I am having hard time installing OVIrt. > > Gluster deployment for the single node sometimes work, but host > engine deployment never works. > > > Any one has suggestion on which release of OVirt to use as a beginner. > > Could you tell what problems you're having and what documentation you're following? I just did a hyperconverged hosted-engine setup on a single server using the cockpit installer and had just 2 problems: - firewall-cmd uses glusterfs as a service name and that isn't installed, its in glusterfs-server rpm but that isn't installed for some reason. - multipath problems but that could be my problem, anyway I manually blacklisted both my SSD gluster drives. Going todo it tomorrow again to get a collegue to work on it so if anything comes up I'll post it here.