for the ovirt side: you can set nfs mount options on the storage domain
settings (Custom connection parameters) but it's recommended to keep
them as is.
Greetings
Klaas
On 7/14/22 03:38, David Johnson wrote:
I have changed the TrueNAS pool setting to synchronous writes =
disabled, and it improved throughput enormously.
I have not been able to figure out how to set the NFS to async -
TrueNAS and Ovirt both seem to hide the NFS settings, and I haven't
found where either of them allows me to configure these.
I am still not seeing anywhere near the throughput on the disks that I
would expect.
Here is what happened creating a VM from the same template. The VM was
created in 2 minutes instead of 30. The graph doesn't show 10x the
throughput, but that is what I see experientially.
image.png
This operation did peg the storage network at 10 gbits very briefly,
but at no point did the hard drives hit as much as 10% of their rated
sustained throughput.
Do you see room for more tuning, or have I tuned this as far as is
reasonable?
Thank you
On Tue, Jul 12, 2022 at 5:25 AM Jayme <jaymef(a)gmail.com> wrote:
David,
I’m curious what your tests would look like if you mounted nfs
with async
On Tue, Jul 12, 2022 at 3:02 AM David Johnson
<djohnson(a)maxistechnology.com> wrote:
Good morning all,
I am trying to get the best performance out of my cluster
possible,
Here are the details of what I have now:
Ovirt version: 4.4.10.7-1.el8
Bare metal for the ovirt engine
two hosts
TrueNAS cluster storage
1 NFS share
3 vdevs, 6 drives in raidz2 in each vdev
2 nvme drives for silog
Storage network is 10 GBit all static IP addresses
Tonight, I built a new VM from a template. It had 5 attached
disks totalling 100 GB. It took 30 minutes to deploy the new
VM from the template.
Global utilization was 9%.
The SPM has 50% of its memory free and never showed more than
12% network utilization
62 out of 65 TB are available on the newly created NFS backing
store (no fragmentation). The TureNAS system is probably
overprovisioned for our use.
There were peak throughputs of up to 4 GBytes/second (on a 10
GBit network), but overall throughput on the NAS and the
network were low.
ARC hits were 95 to 100%
L2 hits were 0 to 70%
Here's the NFS usage stats:
image.png
I believe the first peak is where the silog buffered the
initial burst of instructions, followed by sustained IO as the
VM volumes were built in parallel, and then finally tapering
off to the one 50 GB volume that took 40 minutes to copy.
The indications of the NFS stats graph are that the network
performance is just fine.
Here are the disk IO stats covering the same time frame, plus
a bit before to show a spike IO:
image.png
The spike at 2250 (10 minutes before I started building my VM)
shows that the spinners actually hit write speed of almost 20
MBytes per second briefly, then settled in at a sustained 3 to
4 MBytes per second. The silog absorbs several spikes, but
remains mostly idle, with activity measured in kilobytes per
second.
The HGST HUS726060AL5210 drives boast a spike throughput of 12
GB/S, and sustained throughput of 227 Mbps.
------
Now to the questions:
1. Am I asking the on the right list? Does this look like
something where tuning ovirt might make a difference, or
is this more likely a configuration issue with my storage
appliances?
2. Am I expecting too much? Is this well within the bounds of
acceptable (expected) performance?
3. How would I go about identifying the bottleneck, should I
need to dig deeper?
Thanks,
David Johnson
_______________________________________________
Users mailing list -- users(a)ovirt.org
To unsubscribe send an email to users-leave(a)ovirt.org
Privacy Statement:
https://www.ovirt.org/privacy-policy.html
oVirt Code of Conduct:
https://www.ovirt.org/community/about/community-guidelines/
List Archives:
https://lists.ovirt.org/archives/list/users@ovirt.org/message/BDTES2D7V3K...
_______________________________________________
Users mailing list --users(a)ovirt.org
To unsubscribe send an email tousers-leave(a)ovirt.org
Privacy
Statement:https://www.ovirt.org/privacy-policy.html
oVirt Code of
Conduct:https://www.ovirt.org/community/about/community-guidelines/
List
Archives:https://lists.ovirt.org/archives/list/users@ovirt.org/message/OR...