Hi,
If you're looking at a simple ha bonding setup, why not using active-backup
(mode 1)?
We're using it in almost all our setups and switches toin backup interface
in 100ms when a link down is detected (Setting miimon=100).
Doesn't aggregate bandwidth but is a very good solution for high
availability whwn you can't configure lacp or a portchannel on switch side.
Luca
Il 12 dic 2017 7:06 PM, "Demeter Tibor" <tdemeter(a)itsmart.hu> ha scritto:
Hi,
Thanks for the answers.
In this case the only question is: what is better for me? Mode 5 or 6?
In which modes how is fast the switching?
Until now I've use 802.3ad lacp on our old cluster. I did some tests and
it was very fast. I know it is not same, but mode 5 or 6 how is safe?
Thanks
Regards,
Tibor
----- 2017. dec.. 11., 13:24, Simone Tiraboschi <stirabos(a)redhat.com>
írta:
On Mon, Dec 11, 2017 at 12:53 PM, Demeter Tibor <tdemeter(a)itsmart.hu>
wrote:
> Hi,
>
> Could help anyone for me in this question?
>
Thanks.
>
> R.
>
> Tibor
>
>
>
> ----- 2017. dec.. 6., 14:07, Demeter Tibor <tdemeter(a)itsmart.hu> írta:
>
> Dear members,
>
> I would like to use two switch to make high-availability network
> connection for my nfs storage.
> Unfortunately, these switches does not support 802.3.ad lacp, (really I
> can't stack them) but I've read about mode-alb and mode-tlb bonding
> modes.
> I know,these modes are available in ovirt, but how is work that? Also how
> is safe? Are there for HA or for load balance?
>
> I've read some forums, where does not recommended these modes to use in
> ovirt. What is the truths?
> I would like to use only for storage-traffic, it will be separated from
> other network traffic. I have two 10Gbe switches and two 10Gbe ports in my
> nodes.
>
>
Look here:
https://www.ovirt.org/documentation/admin-guide/
chap-Logical_Networks/#bonds-1
"Important: Modes 1, 2, 3, and 4 support both virtual machine (bridged)
and non-virtual machine (bridgeless) network types. Modes 0, 5 and 6
support non-virtual machine (bridgeless) networks only.¨
So both tlb (mode 5) or alb (mode 6) are fine only if you use them just
for the storage access but not for VMs.
> Thanks in advance,
>
> R
>
> Tibor
>
>
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
>
http://lists.ovirt.org/mailman/listinfo/users
>
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
>
http://lists.ovirt.org/mailman/listinfo/users
>
>
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users