Re: [ovirt-users] workflow node installation
On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
> Don't we have ovirtmgmt defined by default
> during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
> ----- Forwarded Message -----
>> From: "Jorick Astrego" <j.astrego(a)netbulae.eu>
>> To: "users" <users(a)ovirt.org>
>> Sent: Monday, May 19, 2014 1:11:58 PM
>> Subject: [ovirt-users] workflow node installation
>>
>> Hi,
>>
>> I don't know if I'm doing things wrong but the workflow for node
installation
>> is a bit cumbersome for me.
>>
>> The things I have to do to get a node up in ovirt engine:
>>
>> - install node image from pxe
>> - approve node
>> - put node into maintenance mode (storage not available)
>> - Setup Host Networks
>> - Sync network (otherwise I cannot save the network changes)
>> - Setup Host Networks again
>> - Save Network setup
>> - activate node
>>
This seems problematic to me -- the host networks should be
automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have
to approve, log back into the node, configure networking, etc?
>> And this I have to do for every node. It could save me some
time if I could
>> setup the networks on approval or engine puts it directly into maintenance
>> mode without the sync requirement.
>>
>> Kind regards,
>>
>> Jorick Astrego
>> Netbulae B.V.
>>
>> _______________________________________________
>> Users mailing list
>> Users(a)ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
>>