Re: [Users] iSCSI multipath with EqualLogic SAN

I finally had some time to work on this again now that I have some more nodes to work with. I am trying to get the ovirt node to log in from more than 1 IP address to the Equallogic SAN wthout using dell's HIT-Kit. My test node has these interfaces: (all ovirt 3.1, mgmt. and nodes) Eth0 - 10.32.0.44 - ovritmgmt Eth1 - several VM IP data VLANs P1p1 - 10.32.10.44 iscsi network P1p2 - 10.32.10.64 iscsi network My EQ SAN is located at 10.32.10.21. I know there is a ton of issues behind that being the only IP, but right now I have a stranger problem. When I ping 10.32.10.21 like this: Ping 10.32.10.21 -I 10.32.10.44 Tcpdump looking at p1p1 shows pings going as normal from 10.32.10.44 to 10.32.10.21. then I do "ping 10.32.10.21 -I 10.32.10.64" and tcpdump still shows ping packets going from p1p1 and not from p1p2. Tcpdump shows nothing at all on p1p2. I don’t understand how multipath can work if all the packets exit out p1p1 and nothing exits from p1p2? At this point im grasping at straws on how to effectively use the equallogic SAN with ovirt, as our disk thruput is currently limited to 110mb sec from the single 1gig pipe. I tend to be very quick to believe I am on the wrong track here. Any help or advice is greatly appreciated. Thanks, jonathan ________________________________ This is a PRIVATE message. If you are not the intended recipient, please delete without copying and kindly advise us by e-mail of the mistake in delivery. NOTE: Regardless of content, this e-mail shall not operate to bind SKOPOS to any order or other contract unless pursuant to explicit written agreement or government initiative expressly permitting the use of e-mail for such purpose.