Re: [ovirt-users] connecting my oVirt engine to a 100mb switch

The switch is a Cisco 3750 v2, I also tried a cheep Netgear. I'll put in a request to set the Cisco to 100 full and see if that helps. Thanks On Thu, May 28, 2015 at 6:24 AM, Genadi Chereshnya <gcheresh(a)redhat.com&gt; wrote: > Hi Andrew > I am not aware of any issue to connect engine to specific switch (try to > connect other host to the switch to check this assumption) > Looks like it's auto-negotiation issue. > Try to disable it (on the switch side too) > > Regards, > Genadi > > ----- Original Message ----- > From: "Andrew Precht" <andrewprecht06(a)gmail.com&gt; > To: users(a)ovirt.org > Sent: Thursday, May 28, 2015 12:37:57 AM > Subject: [ovirt-users] connecting my oVirt engine to a 100mb switch > > > > > Hi all, > I’m having problems connecting my oVirt engine to a 100mb switch. I’m not > having any problems connecting to 1gb. But, I need to also have a > connection to a 100mb network. > I’ve tried configuring ethtool_opts on the interface. However, this only > results in the NIC not coming up and showing: Speed: Unknown! and Duplex: > Unknown! (255), when I run ethtool ethX > > > Is it possible to connect the engine to a 100mb switch? > Thanks > > > PS. I also posted this question over on the oVirt G+ page. I apologize if > that's incorrect but I have G+ open all day... > _______________________________________________ > Users mailing list > Users(a)ovirt.org > http://lists.ovirt.org/mailman/listinfo/users >