On Thu, 2017-02-23 at 12:47 +0000, Karli Sjöberg wrote:
On Thu, 2017-02-23 at 11:14 +0000, Yaniv Kaul wrote:
>
>
> On Thu, Feb 23, 2017 at 1:11 PM Gianluca Cecchi <gianluca.cecchi@gm
> ai
> l.com> wrote:
> > On Sat, Feb 18, 2017 at 1:35 PM, Karli Sjöberg <karli.sjoberg@slu
> > .s
> > e> wrote:
> > > >
> > > > Thanks for your answer, K!
> > > > So you mean to make a unique bond composed by all 4 network
> > >
> > > adapters and put all the networks on it, comprised ovirtmgmt
> > > and
> > > such, through clans?
> > > > How do you configure 802.3ad on 4 adapters? How many switches
> > >
> > > do you have to connect to, from these 4 adapters? Or do you use
> > > round robin bonding (but I presume it is not supported in court
> > > this bond)?
> > > > Thanks!
> > >
> > > Well, in our case, we have two clustered switches from C-
> > > company
> > > so two NICs in each. And then, yeah, different VLANs for every
> > > network on top of the same bond. Works like a charm:)
> > > /K
> > >
> >
> > Hello K,
> > coming back to the question, I have only 1 VLAN dedicated to
> > Netapp
> > NFS infrastructure and I can't manage to add another.
> > Can I manage to use anyway 802.3ad on 4 adapters using any
> > particular option for this bonding mode at oVirt and switch
> > side?
> > I think that at network side we have 4 x 3130 clustered Cisco
> > switches so in theory I can use this bonding mode.
> > I don't know if I can configure more than one IP on the same lan
> > inside one Netapp svm to configure more that one NFS share.
> > And if 802.3ad mode would assure to use 2 different network
> > adapters when pointing to 2 different ips on the same network for
> > the shares
> >
>
> And multiple mount points, hence multiple SDs? They might, or might
> not use the same physical NIC.
> Y.
In my experience, they will use the same NIC. You need, at least, two
addresses in different subnets for 802.3ad to load balance between
the
interfaces.
/K
P.S. The only thing I can say for sure is that proper load balancing
will occur with separate VLAN interfaces and addresses in different
subnets. That much I know, because that´s how we did it:)
Just using addresses in different subnets may work too, I just don´t
know. Please try and post your results:)
/K
>
> >
> > > And I have to configure parameters for bonding in oVirt too, in
> > > case I have to set any particular one..
> > >
> > > Thanks again,
> > > Gianluca
> > > _______________________________________________
> > > Users mailing list
> > > Users(a)ovirt.org
> > >
http://lists.ovirt.org/mailman/listinfo/users
> > >
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
>
http://lists.ovirt.org/mailman/listinfo/users