I am glad you figured out what the problem is
Genadi
----- Original Message -----
From: "Andrew Precht" <andrewprecht06(a)gmail.com>
To: "Genadi Chereshnya" <gcheresh(a)redhat.com>, Users(a)ovirt.org
Sent: Thursday, May 28, 2015 8:01:19 PM
Subject: Re: [ovirt-users] connecting my oVirt engine to a 100mb switch
It is a hardware issue. Our pass-through's in the c7000 enclosures are not capable of
10/100
On Thu, May 28, 2015 at 7:22 AM, Andrew Precht < andrewprecht06(a)gmail.com > wrote:
The switch is a Cisco 3750 v2, I also tried a cheep Netgear. I'll put in a request to
set the Cisco to 100 full and see if that helps.
Thanks
On Thu, May 28, 2015 at 6:24 AM, Genadi Chereshnya < gcheresh(a)redhat.com > wrote:
Hi Andrew
I am not aware of any issue to connect engine to specific switch (try to connect other
host to the switch to check this assumption)
Looks like it's auto-negotiation issue.
Try to disable it (on the switch side too)
Regards,
Genadi
----- Original Message -----
From: "Andrew Precht" < andrewprecht06(a)gmail.com >
To: users(a)ovirt.org
Sent: Thursday, May 28, 2015 12:37:57 AM
Subject: [ovirt-users] connecting my oVirt engine to a 100mb switch
Hi all,
I’m having problems connecting my oVirt engine to a 100mb switch. I’m not having any
problems connecting to 1gb. But, I need to also have a connection to a 100mb network.
I’ve tried configuring ethtool_opts on the interface. However, this only results in the
NIC not coming up and showing: Speed: Unknown! and Duplex: Unknown! (255), when I run
ethtool ethX
Is it possible to connect the engine to a 100mb switch?
Thanks
PS. I also posted this question over on the oVirt G+ page. I apologize if that's
incorrect but I have G+ open all day...
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users