You can use either LACP or balance round-robin. Of course it is very important to know if your clients will be behind a single IP (for example behind router).As most of the bonding hash policy depend on either MAC (L2) or IP + Port (L3) , you will have a hard time to load balance to clients with the same IP. In my case, I have a team device with 6 x 1GbE ports.As my setup is hyperconverged (replica 3 arbiter 1) , I had to use multiple gluster volumes (and each brick has different port) with 1 VM disk per volume and to stripe on VM level for better performance. Best Regards,Strahil Nikolov В сряда, 24 юли 2019 г., 11:02:48 ч. Гринуич+3, Edoardo Mazza <e.mazza(a)mehrit.it&gt; написа: Hello everyone,I need to create a bond for vm interfaces but I don't kown what is the best solution, you can help me?ThanksEdoardo_______________________________________________ Users mailing list -- users(a)ovirt.org To unsubscribe send an email to users-leave(a)ovirt.org Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/message/TFLL6M32PLE...

Hi Edward, I would make a bond on the host/hypervisor and I would know what is the best solution for the vm traffic, I make an aggregation 802.3ad for the gluster traffic and for the host management, but I don't know if this solution is correct for the vm traffic thanks Edoardo Il giorno gio 25 lug 2019 alle ore 11:15 Edward Haas <edwardh(a)redhat.com&gt; ha scritto: