----- Original Message -----
From: "John Joseph" <jjk_saji@yahoo.com> To: "Yedidyah Bar David" <didi@redhat.com> Cc: users@ovirt.org, "Petr Horacek" <phoracek@redhat.com> Sent: Monday, May 11, 2015 12:25:36 PM Subject: Re: [ovirt-users] My feedback on network setting after installing OVirt
On Monday, 11 May 2015 2:14 PM, Yedidyah Bar David <didi@redhat.com> wrote: ----- Original Message -----
From: "John Joseph" <jjk_saji@yahoo.com> To: users@ovirt.org Sent: Sunday, May 10, 2015 2:37:39 PM Subject: [ovirt-users] My feedback on network setting after installing OVirt
Hi All,
Like to give my feedback about how the network interface behaved after OVirt I have used
CentOS 6.6 64 bit, updated
Ovirt stable from the repo
Now after the installation, and configuration you get "ovirtmgmt" interface and "ovirtmgmt" interface gets the IP address and everything is fine . Now reboot it
result is that when you give ifconfig , eth0 is not displayed and "ovirtmgmt" do not have IP address
This stage solved by giving ifconfig eth0 up
and restarting the network, it will give "ovirtmgmt" an IP now
So you have to do this on every reboot?
Yes on every reboot I have to do it
I tested it using different installation, with DHCP or manual configuration for eth0 , in both the case the same experience
Sounds a bit like [1]. Adding Petr, this bug's owner.
Can you please check/post relevant conf/log files (ifcfg*, vdsm/system logs etc)?
[1] https://bugzilla.redhat.com/show_bug.cgi?id=1154399
Giving my feedback,
Thanks a Lot Joseph John
Thanks, -- Didi
Hello, John, could you please compare your problem with the bug Didi mentioned (but i don't think it's the same case, you don't use a manually created bonding) and if it is not the case, create a new bug entry [2] and provide us logs and exact steps to reproduce? [2] https://bugzilla.redhat.com/enter_bug.cgi?product=oVirt Thanks a lot and best regards, Petr