10:27 a.m.
On Thu, Dec 8, 2016 at 12:42 AM, Mark Steckel <mjs(a)fix.net> wrote:
Hi,
OK, I reset things and tried again but was more more careful regarding the DNS setup
which I believe was correct this. In other words, the FQDNs were resolved from both the
host and the HE VM.
After the latest failure I execute 'ip address' to see the state of the
interfaces. And lo and behold the /29 IP I had on eth0:1 no longer exists.
So some context.
The server's primary IP is a /24 with the gw being the x.y.z.1.
I have have a /29 subnet to use for the VMs.
I have been presuming that I place the a.b.c.1/29 on eth0:1 for the subnet's gw and
OVirt will ether keep it in place or migrate it to the ovirtmgmt device. Instead it is
deleted during "hosted-engine --deploy".(Note, when the .1/29 is assigned to
eth0:1, the IP address is reachable from the the Internet.)
Dnsmasq is configured to a) serve a.b.c.2/29 a.b.c.6/29 via DHCP and b) to resolve unique
FQDNs for each IP. The he VM set to receive the a.b.c.2/29 address.
Am I missing and or just misunderstanding something here?
"eth0:1" is not really a different interface.
Part of the deploy process is to take the interface you have chosen,
create a new bridge, copy part of the configuration from the nic to
the bridge, and add the nic to the bridge. This is one of the most
delicate parts of the process, the one that if fails might leave you
with no network access, the one due to which we recommend to run this
inside 'screen'. You can't do this to "eth0" and keep
"eth0:1"
untouched. You need either a vlan interface or a separate physical
nic. If you feel like this, please open a bug to make 'hosted-engine
--deploy' notice and prevent what you tried to do. Currently it does
not check IP aliases.
Another point - the script that failed is 'engine-setup'. This one
runs inside the engine vm, and keeps its logs in
/var/log/ovirt-engine/setup. If it fails again, please check/post also
these, if at all possible (that is, if you can access the vm).
Thinking about this, it might be possible for 'hosted-engine --deploy'
to get this log, perhaps through the virtual serial connection it
opens to show you the output, and save it on the host side, for easier
debugging. Please open a bug for this too :-)
Thanks, and good luck!
Oh, and does ip_forwarding need to be set in the kernel? (ie net.ipv4.ip_forward=1)
Thanks
Mark
----- Derek Atkins <derek(a)ihtfp.com> wrote:
> Hi,
>
> You need to make sure resolv.conf is correct (both on the host AND on the
> engine vm).
>
> So: dig hostname
> (without the @local-ip)
>
> As for the VM not coming up... I'm not sure how to delay
"engine-setup"
> run. I presume you're running an engine appliance -- I ran my own CentOS
> install on the engine. The logs imply it's suggesting you can access the
> engine VM console, but maybe it's exiting quickly?
>
> -derek
>
> On Wed, December 7, 2016 3:52 pm, Mark Steckel wrote:
> > I tested dnsmasq from the host by
> >
> > dig hostname @local-ip
> >
> > Worked fine.
> >
> > The engine VM never comes up to the point where I can access it via the
> > console...
> >
> >
> > ----- Derek Atkins <derek(a)ihtfp.com> wrote:
> >> Hi,
> >>
> >> Ensure dnsmasq is working and can be accessed by the engine VM?
> >> Log in to the engine VM and test from there?
> >> Maybe set up *real* DNS?
> >>
> >> -derek
> >>
> >> On Wed, December 7, 2016 3:41 pm, Mark Steckel wrote:
> >> > Hi Derek,
> >> >
> >> > ----- Derek Atkins <derek(a)ihtfp.com> wrote:
> >> >> Hi Mark,
> >> >>
> >> >> The error is correct, hosted-engine-1.pcstrac.com is not a valid
> >> >> hostname:
> >> >>
> >> >> $ host hosted-engine-1.pcstrac.com
> >> >> $
> >> >>
> >> >> I'm lost, tho -- was this an error that occurred on the host
during
> >> >> hosted-engine --deploy, or was it an error that occurred in the
> >> hosted
> >> >> enging VM when running engine-setup?
> >> >
> >> > I believe when it occurred when the running the engine-setup.
> >> >
> >> >
> >> >> If the former, you need to ensure that you have a real DNS name
for
> >> your
> >> >> ovirt engine. It's unclear (to me) that using /etc/hosts is
> >> sufficient.
> >> >> However looking at the logs, it looks like it can locally resolve
(to
> >> >> xx.yy.18.122).
> >> >
> >> > Yep. I tested things to make sure it could resolve before I started
> >> the
> >> > 'hosted-engine --deploy'.
> >> >
> >> >> You might need to answer "Yes" to the /etc/hosts
question..
> >> >
> >> > I did answer "Yes".
> >> >
> >> >
> >> >> The log seems to get far enough along that it presents you the
engine
> >> vm
> >> >> console URL? It looks like the issue is that the engine vm cannot
> >> >> resolve
> >> >> its own name.
> >> >
> >> > That is my take as well.
> >> >
> >> > Scratching my head as I config'ed dnsmasq to provide local dns and
to
> >> read
> >> > from /etc/hosts for hosted-engine-1.pcstrac.com.
> >> >
> >> > The only thing I think I flubbed was neglecting to add the host's
IP
> >> to
> >> > the host's /etc/resolv.conf.
> >> >
> >> > Scrubbing and staring again.
> >> >
> >> > Mark
> >> >
> >> >
> >> >>
> >> >> -derek
> >> >>
> >> >> On Wed, December 7, 2016 3:13 pm, Mark Steckel wrote:
> >> >> > Folks,
> >> >> >
> >> >> > Thanks to Didi in another thread I'm making progress.
(Lesson
> >> learned,
> >> >> > choose 'disk' and not 'cdrom' when using the
he-appliance.)
> >> >> >
> >> >> > So I reset to a fresh CentOS 7, installed various software
packages
> >> >> > including ovirt.
> >> >> >
> >> >> > I configed eth0 with a /32 public IP. I also added an alias
for a
> >> >> > x.x.x.1/29 on eth0:1.
> >> >> >
> >> >> > Finally I config'ed dnsmasq to provide both dhcp and dns
(ensuring
> >> >> that it
> >> >> > will read from /etc/hosts before forwarding dns requests) and
added
> >> >> the
> >> >> > IPs and hostsnames to /etc/hosts from the /29 IPs which are to
be
> >> used
> >> >> by
> >> >> > the VMs.
> >> >> >
> >> >> > Things proceeded nicely till resolving the he vm fqdn. (I
tested to
> >> >> make
> >> >> > sure that the he vm fqdm would resolve **Before** I ran
> >> 'hosted-engine
> >> >> > --deploy'.)
> >> >> >
> >> >> > |- --== NETWORK CONFIGURATION ==--
> >> >> > |-
> >> >> > |- [ ERROR ] Host name is not valid:
> >> >> hosted-engine-1.pcstrac.com
> >> >> > did not resolve into an IP address
> >> >> > |- [ ERROR ] Failed to execute stage
'Environment
> >> >> > customization': Host name is not valid:
> >> >> > hosted-engine-1.pcstrac.com did not resolve into an IP
address
> >> >> > |- [ INFO ] Stage: Clean up
> >> >> > |- Log file is located at
> >> >> >
/var/log/ovirt-engine/setup/ovirt-engine-setup-20161207193757-6i03xg.log
> >> >> > |- [ INFO ] Generating answer file
> >> >> >
'/var/lib/ovirt-engine/setup/answers/20161207193758-setup.conf'
> >> >> > |- [ INFO ] Stage: Pre-termination
> >> >> > |- [ INFO ] Stage: Termination
> >> >> > |- [ ERROR ] Execution of setup failed
> >> >> > |- HE_APPLIANCE_ENGINE_SETUP_FAIL
> >> >> > [ ERROR ] Engine setup failed on the appliance
> >> >> > [ ERROR ] Failed to execute stage 'Closing up':
Engine setup
> >> >> failed on
> >> >> > the appliance Please check its log on the appliance.
> >> >> >
> >> >> >
> >> >> > The one thing I forgot is to update /etc/resolv.conf to
include the
> >> >> host
> >> >> > though I don't know if this matters...
> >> >> >
> >> >> > Logs attached.
> >> >> >
> >> >> > I suspect I've very close to having this working but am
admittedly
> >> >> > stumped.
> >> >> >
> >> >> > Pointers appreciated.
> >> >> >
> >> >> > Thanks
> >> >> > Mark
> >> >> >
> >> >> >
> >> >> > _______________________________________________
> >> >> > Users mailing list
> >> >> > Users(a)ovirt.org
> >> >> > http://lists.ovirt.org/mailman/listinfo/users
> >> >> >
> >> >>
> >> >>
> >> >> --
> >> >> Derek Atkins 617-623-3745
> >> >> derek(a)ihtfp.com www.ihtfp.com
> >> >> Computer and Internet Security Consultant
> >> >>
> >> >
> >> >
> >>
> >>
> >> --
> >> Derek Atkins 617-623-3745
> >> derek(a)ihtfp.com www.ihtfp.com
> >> Computer and Internet Security Consultant
> >>
> >
> >
>
>
> --
> Derek Atkins 617-623-3745
> derek(a)ihtfp.com www.ihtfp.com
> Computer and Internet Security Consultant
>
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
--
Didi