Re: [Users] How to pxeboot ovrit node into memory automatically?
Hi Fabian,
Yes rootpwd worked too! Thanks.
Two new problems:
But I found there is no networking for the stateless node.
What kernel boot options are used to either use DHCP or statically configure the IP
address for an interface on the node?
I also need to have the sshd enabled. Is there a kernel option for that?
David
----- Original Message -----
From: Fabian Deutsch <fabiand(a)redhat.com>
To: David Li <david_li(a)sbcglobal.net>
Cc: "users(a)ovirt.org" <users(a)ovirt.org>
Sent: Friday, October 25, 2013 9:10 AM
Subject: Re: [Users] How to pxeboot ovrit node into memory automatically?
Am Freitag, den 25.10.2013, 08:57 -0700 schrieb David Li:
> Hi Fabian,
>
> That kernel option worked for me! The node is booted up in RAM. Thanks!
>
> My next question is:
> How do I specify the root login and passwd as boot parameters?
Hey David.
Nice that it worked! Were you able to register to the Engine?
You can use the adminpw= and rootpw= kernel arguments to set passwords.
use
$ openssl passwd -salt 42
to create one or two passwords
Greetings
fabian
> David
>
>
>
>
> ----- Original Message -----
> > From: Fabian Deutsch <fabiand(a)redhat.com>
> > To: David Li <david_li(a)sbcglobal.net>
> > Cc: "users(a)ovirt.org" <users(a)ovirt.org>
> > Sent: Thursday, October 24, 2013 11:47 PM
> > Subject: Re: [Users] How to pxeboot ovrit node into memory
automatically?
> >
> > Am Donnerstag, den 24.10.2013, 16:26 -0700 schrieb David Li:
> >> Hi,
> >>
> >> I was following the instructions at
http://www.ovirt.org/Node_PXE. My goal
> > is to use pxeboot (iPXE) to boot the node entirely into RAM with
rootfs. What I
> > got now is an installation screen which requires a local storage. My
system has
> > no disk and this doesn't quite work for me.
> >>
> >> What's are the kernel parameters I need to use to boot the
node into
> > RAM automatically? I am OK as the first step with a stateless node.
> >
> > Hey David,
> >
> > the stateless mode is currently not completely working with oVirt
> > Engine. That means a Node needs to be approved each time it boots into
> > the stateless mode.
> > The stateless mode can be entered by appending stateless to the
default
> > kernel arguments.
> >
> > Greetings
> > fabian
> >