Re: [Users] Problems with F17 and ovirt 3.1
On 2012-08-19 12:14, Eli Mesika wrote:
----- Original Message -----
> From: "Veli-Matti Leppänen" <vellu(a)velhot.net>
> To: users(a)ovirt.org
> Sent: Sunday, August 19, 2012 11:47:46 AM
> Subject: Re: [Users] Problems with F17 and ovirt 3.1
>
>
> On 2012-08-19 10:48, Eli Mesika wrote:
> > ----- Original Message -----
> >> From: "Veli-Matti Leppänen" <vellu(a)velhot.net>
> >> To: users(a)ovirt.org
> >> Sent: Saturday, August 18, 2012 1:13:23 PM
> >> Subject: Re: [Users] Problems with F17 and ovirt 3.1
> >>
> >> Hi.
> >>
> >> I tried to install ovirt 3.1 on clean F17 hosts. I tried
> >> all-in-one
> >> and plain manager + node installation, but every time host is
> just
> >> non-responsive.
> >>
> >> vdsmd service does not start
> >> [root@maila ~]# service vdsmd start
> >> Redirecting to /bin/systemctl start vdsmd.service
> >> Job canceled.
> >> and there is no vdsm log.
> >>
> >> selinux or iptables is not the issue, cause setting selinux to
> >> permissive mode or flushing the firewall does not help.
> >>
> >> any ideas where to start?
> >
> > There was an excellent step-by-step video showing how to install
> > all-in-one on top of f17
> > please follow and check again
> >
> >
> http://blog.jebpages.com/archives/up-and-running-with-ovirt-3-1-edition/
> >
>
> I followed that video. Installation times out during adding local
> host.
> Web admin console shows it installing and after that it goes to
> non-responsing state.
Hi again
please refer to the following (taken from the same site)
I’ve found that the all-in-one installer sometimes times out during
the install process. If the script times out during the final “AIO:
Adding Local host (This may take several minutes)” step, you can
proceed to the web admin console to complete the process. If it times
out at an earlier point, like waiting for the jboss-as server to
start, you should run “engine-cleanup” and then re-run
“engine-setup”.
Yeah, I've read that, and problem I have done engine-cleanup and setup
several times. Also same problem (atleast it look like same) is when I
try to add my fresh install of F17 to host. Web gui says that it
installs correctly but after boot it shows non-responding and in the
node vdsmd service does not start.
>
> >>
> >> /Vellu
> >>
> >>
> >> ---
> >> ______________________
> >> Veli-Matti Leppänen
> >> vellu(a)velhot.net
> >> Velzi @ IRC
> >>
> >> _______________________________________________
> >> Users mailing list
> >> Users(a)ovirt.org
> >> http://lists.ovirt.org/mailman/listinfo/users
> >>
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>