
Hello, my configuration is what described here: http://lists.ovirt.org/pipermail/users/2017-March/080992.html So I'm using iSCSI multipath and not bonding can anyone reproduce? Initial situation is only one node configured and active with some VMS I go and configure a second node; it tries to activate but networks are not all already mapped and so gies to non operational. I setup all networks and activate the node It happens that: - on the first node where I currently have 2 iSCSI connections and 2multipath lines (with p1p1.100 and p1p2) it is instantiated a new iSCSI SID using interface "default" and in multipath -l output I see now 3 lines - on the newly added node I only see 1 iSCSI SID using interface default My way to solve the situation was to go inside iscsi multipath section do nothing but save the same config brutally on first node iscsiadm -m session -u --> all iscsi sessions are closed after a while I see again the original 2 connections recovered, with correct interface names used - on second node iscsiadm -m session -u --> the only session is cloed nothing happens if I set to maintenance the node and then activate the node --> the 2 correct iscsi sessions are activated... Thanks Gianluca