[ovirt-users] Re: Info on HCI single host

Yes, Gianluca, that is correct. First, I had to configure a 3 node cluster. There was no other way to get to the setup page shown in my screenshot. I assume when it gets fixed in 4.2.6, we will be able to get to the single node config page right off the bat. On Aug 30 2018, at 8:31 am, Gianluca Cecchi <gianluca.cecchi(a)gmail.com&gt; wrote: On Sat, Aug 25, 2018 at 3:37 AM femi adegoke <oVirt(a)fateknollogee.com&gt; wrote: I was playing around with a 3 node setup. This was on 4.3 based on FC28. In the Cockpit UI, after completing the 1st stage of the hyperconverged setup, I saw this (see pic) Hello, the bugzilla seems in QA, but in 4.2.6 rc3 ovirt node iso (ovirt-node-ng-installer-ovirt-4.2-pre-2018082812.iso) nothing changes: I receive "Host address cannot be empty" for host2 and host3 BTW: Femi, but in your screenshot with F28 the top message containing "An existing gluster configuration has been found." seems to indicate that actually you already configured gluster on that single host, correct? Instead, based on Sahina answer, the single node HCI setup is supposed to work ootb without previously configuring anything related to Gluster, correct? Gianluca _______________________________________________ Users mailing list -- users(a)ovirt.org To unsubscribe send an email to users-leave(a)ovirt.org Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community- guidelines/ List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/ message/EZX7OMTJE53YKDTEPSH22IRBA23TGB7H/