From: "Alan Murrell" <lists@murrell.ca> To: users@ovirt.org Sent: Thursday, August 6, 2015 7:54:06 PM Subject: [ovirt-users] iSCSI question... LUNS->Targets balnk
Hello,
I am hoping someone here has had experience in setting up an iSCSI target using 'targetcli'. I followed the following guide: <http://www.certdepot.net/rhel7-configure-iscsi-target-initiator-persistently/>. This is on my single host (with hosted engine currently running; I am using a seperate HDD for the iSCSI storage)
The iSCSI initiator of my host, from it's information page in oVirt, is <iqn.1994-05.com.redhat:ba4cc8b3368e>, so I created an ACL with that name. Here is a result of the listing in the 'acls' directory for my IQN:
--- START --- /iscsi/iqn.20...gt1/tpg1/acls> ls o- acls .............................................................. [ACLs: 1] o- iqn.1994-05.com.redhat:ba4cc8b3368e ...................... [Mapped LUNs: 1] | o- mapped_lun0 .................................... [lun0 block/block1 (rw)] --- END ---
So it appears as though my host's initiator is mapped to my LUN 0.
When I go in to oVirt and add iSCSI storage, the "Discover" finds my target, and I can even log in successfully, however when I click on the "LUNS->Targets" side tab, there are no LUNs listed, so I cannot add any iSCSI storage.
Any ideas on why the LUN is not showing up?
Have you tried to attach LUN on anything else then oVirt? This way you could find out if it is oVirt or a general issue. j.