On 07/12/2013 11:27 PM, Jason Keltz wrote:
On 12/07/2013 1:27 PM, Mike Burns wrote:
On 07/12/2013 01:22 PM, Jason Keltz wrote:
:) but when I'm in the engine, I can click on the node, and see that it's up. I can click on network interfaces, and see that one is up, and the other are down. I can create networks on the engine, and I can assign the nodes interfaces to those networks, but for the life of me, I can't figure out where I assign an IP to the nodes interfaces!! Surely, the place to do that would be under the "Host" tab, yet it doesn't seem to be there...
Host Tab -> Network Interfaces -> click on Setup Host Networks
On the popup, hover over the logical network (not the nic) and a little pencil or pen (or some other graphic) that is used for editing. Click on that and you'll get another popup where you can choose static/dhcp and set gateway, ip and netmask.
Thank you *so* much! I did not see the little pencil!!!
please open a bug to improve the usability if you couldn't see it...
Happy to help (and yes it was hard to see...)
Actually, Mike -- two of my networks were private and didn't need a gateway... but two are public, and need a gateway! Unfortunately, the interface seems to be missing that option!? It lets you configure an IP, and a subnet mask, but where's the option for specifying a gateway if you're specifying static addresses... (my guess is that it picks up the gateway if you're using DHCP).
multiple gateways? something like this? http://www.ovirt.org/Features/Multiple_Gateways