
21 Apr
2017
21 Apr
'17
1:40 a.m.
Once upon a time, Bryan Sockel <Bryan.Sockel@altn.com> said:
It seems that is some disconnect between my network bridge, the bond and my interfaces. I would like to some how get my bond to use all 4 interfaces. On reboot, it always seems to reset consistently to EM1.
Are you sure the switch side is all the same LACP group? Sounds like one port may accidentally be in a separate group, and that happens to be em1. You might try swapping wires between em1 and another port and reboot and see which ports come up - if all but the port with the wire formerly in em1 come up, it points to the switch config. -- Chris Adams <cma@cmadams.net>