Re: [Users] FW: ovirt 3.2.1 custom bonding options
Hi Dan,
I first tried this without setting miimode, but then miimode pull was set to 0ms (oVirt
engine 3.2.1)
(via /proc/net/bonding/bond[n])
This was the reason why I added miimode=100 setting to custom bonding option in oVirt.
As this is a very common setting, I would suggest to make it default for oVirt too ?
Cheers,
Sven.
Sven Knohsalla | System Administration | Netbiscuits
Office +49 631 68036 433 | Fax +49 631 68036 111 |E-Mail s.knohsalla(a)netbiscuits.com |
Skype: netbiscuits.admin
Netbiscuits GmbH | Europaallee 10 | 67657 | GERMANY
-----Ursprüngliche Nachricht-----
Von: Dan Kenigsberg [mailto:danken@redhat.com]
Gesendet: Mittwoch, 26. Juni 2013 09:04
An: Sven Knohsalla; Lior Vernia
Cc: users(a)ovirt.org
Betreff: Re: [Users] FW: ovirt 3.2.1 custom bonding options
On Wed, Jun 26, 2013 at 01:56:09AM -0400, Sven Knohsalla wrote:
Hi,
for all oVirt users who wants to run their nodes in balance-rr mode:
Go to "Network Interfaces"
--> "Setup Host Networks"
Edit the bond interface you want to change
--> "Bonding mode"--> "Custom:"
--> "Custom mode" --> mode=0 miimon=100 (depends on your scenario)
Is there any reason not to include miimon=100 within the predefined "Mode 0"
selection? I believe that Engine should.