Re: [Users] Network profile lost after host edit

I am now able to reproduce the problem where network profile definitions are lost on VM edit. - Create VM - From the "Network Interfaces" tab, click on "New" and assign the ovirtmgt profile to nic1 - Edit VM, from the "nic1" drop down select another profile and click OK - Edit the same VM again and nic1 lists as <Empty> I upgraded to 3.3.2-1.el6 and still see the problem. As ever, any help is very much appreciated. Thanks, Simon -----Original Message----- From: users-bounces(a)ovirt.org [mailto:users-bounces@ovirt.org] On Behalf Of Simon Barrett Sent: 12 December 2013 21:53 To: Lior Vernia Cc: users(a)ovirt.org Subject: Re: [Users] Network profile lost after host edit Lior, I'm running 3.3.1. I think it may be related to how I created the VM's. Another VM created using the blank template works fine and the network config displays correctly when I click on edit. The problem VM's were created with a different template. I'll dig a bit further to see if I can narrow it down any further. I don't have to click show advanced to exhibit the problem. Thanks for the response Simon > On 12 Dec 2013, at 16:44, "Lior Vernia" <lvernia(a)redhat.com&gt; wrote: > > Hi Simon, > > I apologize for the delay in my response. I've worked quite a bit on > that part of the dialog since oVirt 3.3, and while it was quite buggy > I haven't encountered this exact issue you're describing. It does > remind me of one bug though; could it be that pressing the "Show > Advanced Options" is what triggers the strange behavior? > > What version of oVirt engine are you running? Both 3.3.1 and 3.3.2 > should be quite stable as far as this dialog is concerned, so > upgrading might be a good idea. > > As for workarounds, it sounds like a GUI issue so I don't think > there's anything you can do apart from upgrading the engine. > > Yours, Lior. > >> On 11/12/13 13:40, Simon Barrett wrote: >> I have a problem where VM network profiles are lost when editing a host. >> E.G. >> >> >> >> * VM is running fine on the correct network. Network Interfaces >> tab shows "nic1" and "Network Name" shows the correct network profile. >> >> * I shutdown the VM then right click and Edit. >> >> * The General settings for the node shows "nic1 <Empty>". If I >> then edit config, something like increasing memory or changing CPU >> cores then click on OK, the VM configuration is saved without a network profile. >> >> * When I boot the VM I cannot connect to it. >> >> * I then have to edit the node again configure back in the >> correct network profile. >> >> >> >> Does anyone know if this is a known issue? If not, any suggestions as >> to how I correct this so that the original network profile definition >> is retained after an edit? >> >> >> >> Many thanks, >> >> >> >> Simon >> >> >> >> >> >> _______________________________________________ >> Users mailing list >> Users(a)ovirt.org >> http://lists.ovirt.org/mailman/listinfo/users >> _______________________________________________ Users mailing list Users(a)ovirt.org http://lists.ovirt.org/mailman/listinfo/users