Re: [ovirt-users] how to remove VM and Hosts ?

I reinstalled the hosts step: 1) create new host > I selected srv-02 2) host created 1) create new host > I selected srv-03 2) host created and noticed two things : 1) I tried now, to remove the remaining VMs , but the error was the same : Cannot remove VM. VM is attached to a VM-Pool. 2) I can run theses VMs . That is, I can remove the host and reinsert again without VM problems. 2.1) And another detail: these VMs are thin/dependent. All others VMs that I was able to remove was the type clone/independent. What happens with this thin type provisioning? On Tue, May 6, 2014 at 1:42 PM, Tamer Lima <tamer.americo(a)gmail.com&gt;wrote: > hello > > what is the correct procedure to remove VMs and Hosts? > I know the right way is to remove VMs first then remove your Host, > but I generate 20 VMs, just for testing, and I want to remove either the > host who hosts this VMs > > Environment: > 3 servers: > srv-01 = engine , vdsm > srv-02 = vdsm , spm, lots of VMs > srv-03 = vdsm , lots of VMs > > > I removed 2 hosts of my ovirt-engine > steps: > 1) select host and put on maintenance > 2) stop all VMs > 3) remove host > > But in VM tab I can see all VMs and can not remove . > > steps > > 1) select VM and click on remove > Are you sure you want to remove the following items? > - pvm0203-2 > Remove Disk(s) > > 2) click ok > Operation Canceled > Error while executing action: > pvm0203-2: > Cannot remove VM. VM is attached to a VM-Pool. > > > What really happens here? Where is this files located to remove > manually? > > thanks > > > thanks > > >