Re: [ovirt-users] My feedback on network setting after installing OVirt
On Mon, May 11, 2015 at 10:25:36AM +0000, John Joseph wrote:
On Monday, 11 May 2015 2:14 PM, Yedidyah Bar David <didi(a)redhat.com> wrote:
----- Original Message -----
> From: "John Joseph" <jjk_saji(a)yahoo.com>
> To: users(a)ovirt.org
> Sent: Sunday, May 10, 2015 2:37:39 PM
> Subject: [ovirt-users] My feedback on network setting after installing OVirt
>
> Hi All,
>
> Like to give my feedback about how the network interface behaved after OVirt
> I have used
>
> CentOS 6.6 64 bit, updated
>
> Ovirt stable from the repo
>
> Now after the installation, and configuration you get "ovirtmgmt"
interface
> and "ovirtmgmt" interface gets the IP address and everything is fine .
Now
> reboot it
>
> result is that when you give ifconfig , eth0 is not displayed and
"ovirtmgmt"
> do not have IP address
>
> This stage solved by giving ifconfig eth0 up
>
> and restarting the network, it will give "ovirtmgmt" an IP now
So you have to do this on every reboot?
Yes on every reboot I have to do it
>
>
>
> I tested it using different installation, with DHCP or manual configuration
> for eth0 , in both the case the same experience
Sounds a bit like [1]. Adding Petr, this bug's owner.
Can you please check/post relevant conf/log files (ifcfg*, vdsm/system logs etc)?
[1] https://bugzilla.redhat.com/show_bug.cgi?id=1154399
I don't think that the bug is related, as Joseph's case lacks any bond.
Network should have been restored by Vdsm on its start up. However, in
ovirt-3.5.0 there were cases where this has failed. Furthermore, we
still have
1203422 vdsm should restore networks much earlier, to let
net-dependent services start
that is still on our TODO list.
To understand precisely what happens on your host, we'd need your vdsm
version, and as Didi asked - your {super,}vdsm.log and /var/log/message.
However, to avoid the need of re-solving a solved bug, verify that you
use vdsm-4.16.14 or later.