Are you using built in nics on your hypervisor? If so, then pci passthrough
will likely pass both as they as possibly on the same pci device. At least
that is how my dells work. Honestly you should just be able to put nic two
on its own network untagged and then assign that network to the hypervisor
with the connection. Without SR-IOV support those nics will be dedicated to
that VM.
Just depends on your use case. What is the big picture?
On Tue, Dec 26, 2017 at 9:12 PM Alex Bartonek <Alex(a)unix1337.com> wrote:
Yes, enabled io-mmu. I'm not sure if what I'm doing is
right though. So
if there is a better way of accomplishing what I'm trying to do, send me to
some reading material so I dont take up too much of everyone's time. I'll
read up on it. If its a simple do-this-and-that, then I'll try it.
Thanks!
Sent with ProtonMail <
https://protonmail.com> Secure Email.
-------- Original Message --------
Subject: Re: [ovirt-users] Assign external IP to VM
Local Time: December 26, 2017 7:17 PM
UTC Time: December 27, 2017 1:17 AM
From: donny(a)fortnebula.com
To: Alex Bartonek <Alex(a)unix1337.com>
users(a)ovirt.org <users(a)ovirt.org>
Looks like you are trying to use SR-IOV. Did you enable iommu on the
hypervisors? Do your hypervisors support SR-IOV.
On Tue, Dec 26, 2017 at 5:38 PM, Alex Bartonek <Alex(a)unix1337.com> wrote:
> Need some guidance on this one.
>
> Config:
> 1U with 2 NICs.
> NIC 1 plugged to local switch - gets local IP
> NIC 2 plugged direct to cable modem - need to set IP inside VM to public
> static IP
> VM will be CentOS, already know how to configure NIC once I can get the
> 2nd NIC assigned to it.
>
> Do I use PCI passthru? Or where do I start to get this configured? I
> did setup NIC 2 under Network --> Networks. Created a NIC called
> "external_NIC". External NIC has description and then I configured 2 DNS
> servers which are given to me by the ISP.
>
> Under Compute --> Hosts --> <My Host> --> Network Interfaces (I have
both
> NICs showing as up) --> Setup Host Networks ---> NIC 2 is the interface -->
> Assignment of Logical networks is "external_NIC".
>
> I was assuming I was done, so I go to my VM add NIC 2, click run and I
> see:
>
> Cannot run VM. There is no host that satisfies current scheduling
> constraints. See below for details:
>
> - The host <MY HOST> did not satisfy internal filter Network because
> there are no free virtual functions which are suitable for virtual nic(s)
> nic2. A virtual function is considered as suitable if the VF's
> configuration of its physical function contains the virtual nic's
> network/network label.
>
> Need guidance on what to read to get this working.
>
> Thanks!
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
>
http://lists.ovirt.org/mailman/listinfo/users
>
>