Re: [Users] Created ovirt 3.3 node (3.1 hypervisor) ISO but not 100% right?

I created ovirt node ISO but it is not 100% right. Boots, media check is fine, the UI executes, can select disk device as expected, enter password, etc. When the install sequence starts… it just stops at 0% “Starting…” then nothing happens. Tried it with IDE, SATA, even SCSI, all local attached, even tried it in a VM (nesting enabled, etc.), and same issue appears to freeze. Jumping to alternate consoles, all blank. Tried to run install in text mode, removed quiet and rhgb options from boot command-line, but the UI takes over so no help. When I generated the ISO image, did not notice any errors, source platform for ISO image was Fedora 19 minimal install plus all the adds as outlined on the ovirt node build documentation web page. Anyone run into the same odd issue? Am able to install Fedora 19 on same hardware, so can’t see why node install would fail, since am able to select disk drive, but can’t write to it? Very odd.